My initial thought was to drill a pilot hole and use a screw. This is so much simpler. gundamboi1234. • 2y ago. happens to me too. Reddit·r/Gunpla

Removing a "piece" varies greatly depending on whether you're dealing with a kitchen task, a puzzle, or home maintenance.

: To remove the tough silverskin from ribs, insert a butter knife or the tip of a spoon between the membrane and the bone at one end of the rack. Once loosened, use a paper towel for a better grip to peel the entire piece off in one go.

: To remove the breast from a whole chicken, use a sharp knife to make small cuts along the bone, then pull the meat away from the carcass. For spatchcocking, you can remove the backbone or keel bone by cutting along both sides with kitchen shears or a knife. Toys & Puzzles

: Turn the top layer 45 degrees . This allows you to get your thumb under an edge piece to pop it out without damaging the internal tabs. Once the edge is out, the corner pieces can be easily removed.

: These often require a specific sequence of sliding and rotating. For example, moving one piece to the side, sliding another back, and then moving a third inward to "unlock" the final removal. Home & Hardware Tips on how to remove the broken stand piece ? : r/Gunpla