Bullet Zip - Шєщ†шіщљщ„ Open

: Cut a vertical channel inside the frame that aligns with the ejection port so that the "magazine" (a smaller paper roll) is visible through the opening.

: Use a separate piece of paper to line the inside of the slide to create a "flush" look when the slide is pulled back, showing the chamber area. Materials Needed Paper/Cardstock : For a sturdy build. Adhesives : Glue or clear tape. ШЄЩ†ШІЩЉЩ„ Open Bullet zip

Carefully cut out this rectangle to represent the area where a bullet casing would be ejected on a real firearm. Ensure you do not cut too deep to maintain the structural stability of the paper . : Cut a vertical channel inside the frame

Mark an open rectangle midway through the gun's frame, near where the magazine would sit. Adhesives : Glue or clear tape

: Scissors or a precision craft knife for the ejection port.

: Roll or fold heavy paper into rectangular tubes to form the body and the sliding top of the pistol. Create the Ejection Port :

: A ruler and pencil for marking the cut-out.